Feed your 2020-2026 Chevy Corvette C8 6.2L V8 more cold air with the aFe Power Magnum FORCE Stage-2 Cold Air Intake System with Pro 5R Filters. aFe dyno testing shows gains of up to +12 horsepower and +10 lb-ft of torque, and the system outflows the factory intake by 15% at a measured 605 CFM @ 7in H2O.
aFe Power pairs a heat-resistant XLPE housing that connects to the factory air inlets on each side of the car and seals to the trunk cover with a computer-designed, dyno-tuned XLPE intake tube. The Pro 5R filters use five-layer progressively finer cotton gauze media, pre-oiled for maximum airflow, and they are washable and reusable for the life of the vehicle. The kit installs using factory mounting locations.
Features:
- Dyno-proven gains up to +12 HP and +10 lb-ft of torque
- Outflows the factory intake by 15% - 605 CFM at 7in H2O
- Dual 4in flange 360-degree radial flow Pro 5R filters
- Heat-resistant housing encloses the dual air filter setup
- Housing seals to the trunk cover to block warm engine air
- Silicone bellow couplings allow for engine movement
- Factory harness, mounts and antenna transfer to the aFe housing
- Premium stainless steel clamps and silicone couplings
Specifications:
- Brand: aFe Power
- Part Number: 54-13055R
- Type: Cold Air Intake System
- Series: Magnum FORCE Stage-2
- Filter Media: Pro 5R Oiled Cotton Gauze
- Filter Color: Blue
- Filters Included: 2
- Horsepower Gain: +12 HP
- Torque Gain: +10 lb-ft
- Air Flow Gain: 15%
- Replacement Air Filter: 24-91020-MA
- Mounting Hardware Included: Yes
- ECU Tuning Required: No
Included:
- (1) XLPE Intake Housing with Seal Trim
- (1) Dyno-Tuned Intake Tube
- (2) Pro 5R Pre-Oiled Air Filters
- Stainless Steel Clamps, Silicone Couplings and Hardware
Fitment:
- 2020-2026 Chevy Corvette (C8) 6.2L V8
Notes:
- Not legal for sale or use in the state of California
- Fits convertible models, but the seal trim will not fully seal to the trunk cover - aFe recommends 58-10007R or 58-10007D for convertibles
- Removing the radio antenna from the factory air box requires cutting off two melted plastic mounting tabs