Zone Offroad 3 Inch Lift Kit | Dodge Ram 2500 Power Wagon (10-13) 4WD

Go big and go anywhere with this 5" Lift Kit for your truck that gives you clearance for huge tires up to 36". This kit has everything you need to raise your 4WD 2010 - 2013 Dodge / Ram 2500 / 3500 Truck. If you’re going to do it, do it right.

Features:

• 100% bolt-on design for easy installation.
• Bump stop extensions properly limit up-travel, protecting your vehicle.
• Heavy-duty upper and lower control arms improve strength and articulation while correcting caster.
• Heavy-duty front track bar bracket correctly positions front axle under vehicle.
• Steering components included to ensure smooth post-installation operation of steering system and factory-consistent vehicle handling characteristics.

Fitment:

• 2010 - 2010 Dodge/Ram 2500 Power Wagon

Included:

• All Necessary Mounting / Installation Hardware
• Bump Stop Extensions
• Coil Springs
• Control Arms
• Dropped Pitman Arm
• Rear Lift Block & U-Bolt Kit
• Sway Bar Relocation Brackets
• Track Bar Relocation Bracket

Notes:

• Check Rear Axle Diameter: This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
• Fitment: This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
• Gas Engine? Gas models may sit slightly taller than the advertised lift height due to lighter weight of engine.
• Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.