Snow Performance 450 Power-Max Water-Methanol Injection System

The Snow Performance 450 POWER-MAX Water-Methanol Injection System provides you with horsepower, torque and lower EGT's. The POWER-MAX™ system comes equipped with the boost referenced VC-50 controller and has the ability to progressively command 2 Snow Performance Hyper-Sonic Nozzles independently of one another. This sophisticated injection strategy yields a dyno proven 65+HP and 200-300 degree drop in EGTs!

The VC-50 comes with a dual 7 color LED screen and displays boost, percentage of injection, low level, and 2 fault modes (clogged line/unplugged line) directly on the screen. Utilizing a truck specific Snow Performance Injection Boot (Rated to 65 PSI) no drilling is required of the intake piping and allows the location of 2 Snow Performance Hyper-Sonic Nozzles right where you need it. If you are looking for the most advanced, high quality, U.S.A made water-methanol injection system tailored to your Diesel Truck than look no further than the Snow Performance POWER-MAX™.

Features:

• Lower Exhaust Gas Temperatures
• Increased Horsepower
• Increased Torque

Kit Includes:

• 300 PSI Extreme Environment UHO (Ultra High Output) Pump
• All Tubing Necessary for Installation
• 10 ft ¼ Inch High Temp Nylon Tubing
• 36 Inches High pressure Boost Line
• 3 ft (Black) Wire Loom
• Terminated 2 1/16 Gauge Style Meth Controller
• Universal 2 1/16 Gauge Pod
• Wire Harness
• Power Solenoid Upgrade
• Bulkhead Fitting to Tap Into Stock Windshield Washer Fluid
• Diesel Injection Boot (Vehicle Specific Systems Only)
• 2 Nozzle Holder/Check Valve Combo
• 3 Snow Performance Nozzles to cover a wide range of HP
• Required Hardware Needed For Installation
• Comprehensive Instructions to Install on Any Diesel Truck