Home - Return to Previous Page
Additional Images

Shock Therapy Bump Steer Delete Tie Rod Kit For 17-19 Can-Am Maverick X3 72"

Pricing: $199.95

Customize Your Item

- Please Select -
 * required
CA Prop 65
FREE Ground Shipping


Shock Therapy Bump Steer Delete Tie Rod Kit For 2017-2019 Can-Am Maverick X3 - 72" Width


Our new BSD™ Tie rod kit is here and does wonders for your Can Am X3 RS. Through rigorous testing of our shop car, we found that the X3 RS had a lot of steering wheel feed back in the whoops especially if you run a larger tire and turning in the whoops. After cycling the front suspension we found over 4 inches of bump steer in the factory system. Bump steer is a change in toe setting (front of tires closer together than the rear of the tires) through the cycle of front suspension travel. The best set up is as close to zero toe change as possible. If your front tires change toe setting they are essentially doing the same thing as you turning the steering wheel slightly on every bump you hit. Bump steer is one of the biggest contributors to steering wheel feedback, twitchy drive ability, excessive front end wear and worn out forearms from trying to keep the car straight. So in an effort to eliminate all of these things we developed our BSD™ (bump steer delete™) tie rod kit for the X3 RS. Our kit relocates the outer tie rod pivot point which changes the front end geometry and lowers the factory 4 inch bump steer measurement down to just 3/8 of an inch! With the bump steer removed the car is much easier to drive, steer and control. What used to be a two handed steering wheel grab to hold the car in whoops is now just a few fingers on one hand. Your front end parts will last longer. Your car will drive more predictably. Your forearms will have no arm pump. The whole driving experience will become easier. Don't wait, install our BSD™ Tie Rod Kit today.



  • 2017-2019 Can-Am Maverick X3 RS 2 Seat (72")
  • 2017-2019 Can-Am Maverick X3 RS Max 4 Seat (72")
  • 2018-2019 Can-Am Maverick X3 RC (72")
  • 2017-2019 Can-AM Maverick X3 XMR (72")
  • 2017-2019 Can-AM Maverick X3 RR (72")


Note: This kit is designed to fix the geometry of the factory arm configuration. It is NOT designed for any aftermarket arm system.





Shipping Information

  • Item Requires Shipping
  • 10.0 lbs.
  • W29.0000” x H5.0000” x L5.0000”
  • FREE Ground Shipping

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.